ISO INTERNATIONAL STANDARD 13374-4 Firstedition 2015-12-01 Condition monitoring and diagnostics of machine systems Data processing, communication and presentation - Part 4: Presentation Surveillance et diagnostic d'état des machines - Traitement, échange et présentation des données Partie4:Présentation Reference number IS0 13374-4:2015(E) SO International Organization for Standardization @ IS0 2015 ted without license from IHS IS0 13374-4:2015(E) COPYRIGHTPROTECTEDDOCUMENT IS0 2015, Published in Switzerland All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form or by any means, electronic or mechanical, including photocopying, or posting on the internet or an intranet, without prior written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISOcopyrightoffice Ch. de Blandonnet 8 . CP 401 CH-1214 Vernier, Geneva, Switzerland Tel.+41 22 749 01 11 Fax +41 22 749 09 47 [email protected] www.iso.org Intenatinair PrganizationforStandardization ensee-ZHEJIANG INST.OF STANDARDIzARoISQ15- All rights reserved Not for Resale, 2016/3/29 05:18:48 etworking permitted without license from IHS IS0 13374-4:2015(E) Contents Page Foreword ..iv Introduction. 1 Scope. ..1 2 Normative references ..1 3 Terms and definitions 4 Open CM&D information architecture presentation requirements ..1 4.1 Overview .1 4.2 Basic requirements .2 4.3 Authentication and authorization requirements .2 4.4 Internationalization and localization requirements .2 4.5 User tracking requirements 2 4.6 User configuration requirements .2 5 Open CM&D processing architecture presentation requirements .3 5.1 Overview 3 5.2 Technical display (TD) module requirements ..4 5.3 Information presentation (IP) module requirements 4 Bibliography .5 iii e=ZHEJIANG INSTOF STANDARDIZATION C15956617 vided by IHS underI thout license from IHS